Kia Sorento: Adjustment - ETC (Electronic Throttle Control) System - Engine Control System - Engine Control / Fuel SystemKia Sorento: Adjustment

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System / Adjustment

After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
2.
Select "Data Treatment", to reset the ETC adaptive value.

3.
Select "Resetting adaptive values".

4.
Select "Reset", then wait 10 seconds after turning ignition key off (Relay OFF).

5.
Wait for 5 seconds after turning the ignition ON (ETC adaptive value relearn).
If equipped with Button Engine Start System, push the engine start/stop button 2 times without depressing the brake pedal. This will allow the ECM to automatically learn the throttle valve position; then wait for approximately 5 seconds.

Enable conditions : Battery > 10V, Intake Air Temp. > 5.3
    See also:

    Special Service Tools
    Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture(Beam) Removal and installation of the transaxle. Except lo ...

    Lane Following Assist (LFA)
    Lane Following Assist can detect lane markings or a vehicle ahead on the road and center your Kia Sorento in the lane. Detection sensor Please refer to Detecting sensor(s) for the applicable ...

    Specification
    Tightening Torque Tightening Torque Interior Trim Center Pillar Lower Trim Item N·m kgf·m ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0543