Kia Sorento: Driver's and passenger's front air bag

Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating position.
The indication of the system's presence are the letters "AIR BAG" embossed on the air bag pad cover on the steering wheel and the passenger's side front panel pad above the glove box.
The SRS consists of air bags installed under the pad covers in the center of the steering wheel and the passenger's side front panel above the glove box.
The purpose of the SRS is to provide the vehicle's driver and/or the front passenger with additional protection than that offered by the seat belt system alone in case of a frontal impact of sufficient severity. The SRS uses sensors to gather information about the driver's and front passenger's seat belt usage and impact severity.
WARNING
If the occupant detection system is not working properly, the SRS air bag
warning light
on the instrument panel
will illuminate because the SRS air bag warning light is connected with the occupant
detection system. If the SRS air bag warning light does not illuminate when the
ignition switch is turned to the ON position, remains illuminated after approximately
6 seconds when the ignition switch is turned to the ON position, or if it illuminates
while the vehicle is being driven, have an authorized Kia dealer inspect the advanced
SRS air bag system as soon as possible.
The seat belt buckle sensors determine if the driver and front passenger's seat belts are fastened.
These sensors provide the ability to control the SRS deployment based on whether or not the seat belts are fastened, and how severe the impact is.
The advanced SRS offers the ability to control the air bag inflation with two levels. A first stage level is provided for moderate-severity impacts.
A second stage level is provided for more severe impacts.
The passenger
Component Location
1. Battery
2. AC inverter switch
3. AC inverter unit
4. AC inverter outlet
...
Rear Glass Defogger Printed Heater Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on th ...