Kia Sorento: Engine And Transmission Assembly Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine And Transmission Assembly Installation

Install the other parts in reverse order of removal.

Perform the following :

•	Adjust a shift cable.

•	Refill engine with engine oil.

•	Refill a transaxle with fluid.

•	Refill power steering fluid.

•	Refill a radiator and a reservoir tank with engine coolant.

•	Place a heater control knob on "HOT" position.

•	Clean battery posts and cable terminals and assemble.

•	Inspect for fuel leakage.

-	After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.

-	Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.

•	Bleed air from the cooling system.

-	Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)

-	Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.

Engine And Transmission Assembly Removal

• Use fender covers to avoid damaging painted surfaces. • To avoid damage, ...

Timing System

...

See also:

Front Body E
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Hood hinge m ...

Reverse Parking Collision-Avoidance Assist settings
Parking Safety ...

Installation
1. Install in the reverse order of removal. If the oil seal on the trans ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026