Kia Sorento: Front Stabilizer Bar Removel - Front Suspension System - Suspension SystemKia Sorento: Front Stabilizer Bar Removel

Kia Sorento (XM, 2011-2015) Service Manual / Suspension System / Front Suspension System / Front Stabilizer Bar Removel

1.
Remove the front wheel and tire (A) from front hub .

Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).

2.
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.

Tightening torque:
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Remove the sprit pin and castle nut and then disconnect the tie-rod end (A) from the front knuckle.

Tightening torque:
23.5 ~ 33.3N.m (2.4 ~ 3.4kgf.m, 17.4 ~ 24.6lb-ft)

4.
Loosen the bolt & nut and then remove the lower arm (A).

Tightening torque:
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

5.
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.

Tightening torque:
32.4 ~ 37.3N.m (3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft)

  
    1. Check the bushing for wear and deterioration. 2. Check the lower arm for bending or breakage. 3. Check the lower arm ...
    1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation....
    See also:

    Oil Temperature Sensor (E-Module) On Vehicle Inspection
    Inspection 1. The automatic transaxle system can be more quickly diagnosed for problems by using the vehicle diagnostic sys ...

    Front Oil Seal Repair procedures
    Replacement 1. Remove the crankshaft damper pulley. (Refer to Drive Belt System - "Crankshaft Damper Pulley") ...

    Special Service Tools
    Tool(Number and Name) Illustration Use 09495-3K000 Band installer Installation of ear type boot band 09568-4A000 Ball joint ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0704