Kia Sorento: Input Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle SystemKia Sorento: Input Speed Sensor Removal

Kia Sorento (XM, 2011-2015) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Removal

1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section....
Input Speed Sensor Installation
1. Install in the reverse order of removal.   ...
See also:

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts may be act ...

Special Service Tools
Special Service Tool Tool Name / Number Illustration Description Airbag deploy ...

Headlamp Leveling System
Headlamp Leveling Switch Repair Procedures Removal 1. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Low ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0487