Kia Sorento: Inspection - Windshield Deicer - Body Electrical SystemKia Sorento: Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Windshield Deicer / Inspection

1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper motor linkage.

3.
Check for continuity between the terminals of deicer lines.

4.
Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

OK : approx. Battery voltage (12V)

Description
Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an inp...
Windshield Deicer Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel (A). (Refer to Body - "Crash pad") ...
See also:

Vehicle Stability Management (VSM) system. Trailer Stability Assist (TSA) system
Vehicle Stability Management (VSM) system The Vehicle Stability Management (VSM) system works in harmony with the Electronic Stability Control and Motor-Driven Power Steering to further enhance ...

High beam operation. Turn and lane change signal operation. One-touch lane change function
High beam operation To turn on the high b ...

Disc Brakes and Pads Repair procedures
Inspection Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage. Front Brake Disc Thickness Check 1. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.045