Kia Optima Manuals

Kia Sorento: IPM Function - BCM (Body Control Module) - Body Electrical SystemKia Sorento: IPM Function

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / BCM (Body Control Module) / IPM Function

1.
Wiper & Washer Control
(1)
Front Washer Interlocking Wiper Control
If washer switch (WasherSW) is ON at the status of IGN2 ON, Wiper turn ON. If washer switch is OFF, wiper turn ON for 2.5~3.8 seconds and then turn OFF.
(2)
Front Wiper Intermittent Control
If front wiper INT switch is ON at the status of IGN2 ON, wiper turn ON according to INT volume.
(3)
Front Wiper MIST Control
If front wiper MIST switch is ON at the status of IGN2 ON, wiper turn ON continually.
(4)
Rear Washer Interlocking Rear Wiper Control
If rear washer switch is ON at the status of IGN2 ON, Wiper turn ON. If rear washer switch is OFF, rear wiper turn ON for 2.5~3.8 seconds and then turn OFF.
(5)
Rear Wiper Control
If rear wiper switch is ON at the status of IGN2 ON, rear wiper turn ON continually.
(6)
Rear Wiper Intermittent Control
If rear wiper INT switch is ON at the status of IGN2 ON, rear wiper turn ON according to INT volume.
2.
Warning
(1)
Seat Belt Reminder (Front)
ConditionS
 Warning Pattern
Seat Blet
 Vehicle Speed
 Light-Blink
 Chime-Sound
Unbuckled
 6 seconds
Bucked
 6 seconds
 None
Bucked → Unbuckled
 Below 3 mph
(5 km/h)
 6 seconds
 None
3 mph
(5 km/h) ~
6 mph
(10 km/h)
 6 seconds
Above 6 mph
(10 km/h)
 6 seconds on/ 24 seconds off
(11 times)
Unbuckled
 Above 6 mph
(10 km/h)
↓
Below 3 mph
(5 km/h)
 6 seconds
↓
Stop

(2)
Parking Brake Start Warning
If the vehicle speed is over 5 km/h & parking brake switch ON & IGN ON, the parking brake waring sound is ON.
3.
Rear defogger
(1)
If rear defogger switch turns ON after Alt L is ON while IGN1 is ON, turn the defogger relay output ON for 20min.
(2)
If rear defogger switch turns ON again while defogger relay output is ON, turn the defogger relay output OFF.
(3)
Also turn defogger output OFF in case of Alt L OFF or IGN1 OFF while the defogger relay output is ON.
4.
Power Window Timer
(1)
Turn the safety and power window ECU output ON when turning IGN1 ON.
(2)
Turn safety power window ECU output OFF after keeping safety power window ECU output for 30sec when IGN1 is OFF.
(3)
Turn safety power window ECU OFF immediately when opening the driver door or assist door within the condition (2) above.
5.
Exterior Lamp Control
(1)
Tail Lamp Auto Cut
If the key out and driver door is opened while the key or ACC or IGN ON and tail lamp switch ON, turn the tail lamp relay OFF automatically.
When turning tail lamp switch ON again from OFF after the automatic blackout, the tail lamp relay will be turned ON and Tail Lamp Auto Cut function will be cancelled.
(2)
Auto Light Control
If the value of Auto Light Signal is input value of LIGHT ON at the status of IGN1 ON and the auto light switch ON, turn the light ON in 2.5sec
    IPM (Intelligent intergrated Platform Module) receives various input switch signals ling time and alarm fuctions for fr washer interlocking wiper, fr intermittent wiper, mist wiper, rear washe...
    1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...
    See also:

    Cylinder Block Disassembly
       ...

    Emission control system
    The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Maintenance booklet in your vehicle. Your v ...

    [CVVT System Mode]
    (1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

    Manuals list

    Copyright © xm.ksmanual.com 2014-2026 - 0.0454