Kia Sorento: Rear Upper Arm Removal - Rear Suspension System - Suspension SystemKia Sorento: Rear Upper Arm Removal

Kia Sorento (XM, 2011-2015) Service Manual / Suspension System / Rear Suspension System / Rear Upper Arm Removal

1.
Remove the rear wheel and tire (A) from rear hub .

Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Support the rear lower arm (A) with a jack as shown in the illustration.
  
Certainly install Jack as being danger because of the tension.

3.
Loosen the bolt & nut and then remove the rear upper arm (A).

Tightening torque :
2WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
4WD
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

[2WD]

[4WD]

4.
Installation is the reverse of removal.
Rear Shock Absorber Installation
1. Installation is the reverse of removal.    After checking the distance 454...
Rear Upper Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear upper arm or damage and deformation. 3. Check for...
See also:

Tightening Torques
Item N.m kgf.m lb-ft Ignition coil installation bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug installation 14.7 ~ 24. ...

Powernet Domain Controller On Vehicle Inspection
On Vehicle Inspection Diagnostic with KDS 1. PowerNet domain controllers can quickly diagnosed for prob ...

Rear Door Trim Repair Procedures
Removal 1. Disconnect the battery negative ( - ) terminal. 2. Remove the rear ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0655