Kia Sorento: Release Residual Pressure in Fuel Line
Whenever the high pressure fuel pump, fuel pipe, delivery pipe,
or injector is removed immediately after shutting off the engine, an
injury may be caused by the release of highly pressurized fuel. Release
the residual pressure in the high pressure fuel line by referring to
the "Residual fuel pressure release procedure" below before removing
any high pressure fuel system components.
|
Wear safety glasses and fuel resistant gloves.
|
| 1. |
Turn the ignition off and disconnect the battery negative cable.
|
| 2. |
Remove the fuel pump fuse (A).
|
| 3. |
Disconnect the electrical connector from the high pressure fuel
pump.
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
Run the engine for about 20 seconds to lower the pressure in both
the high or low pressurelines. The engine may shut off within the 20
second period. If not, turn the engine off.
|
| 6. |
Proceed with the service or repair. Use rags to cover opening
and catch spills when opening up the high pressure system.
|
| 7. |
Reinstall / re-connect all components in reverse order of removal.
Start engine and confirm proper operation, and make sure there are no
fuel leaks.
|
| 8. |
After completing, clear DTC(s) using GDS scan tool (the procedure
described above will cause DTC to set).
|
Road warning. Hazard lights switch. If the engine does not start
Road warning. Hazard lights switch
When an unexpected emergency situation occurs while you are driving your Kia Sorento or when you are forced to park along the edge of the road, immediately turn you ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the ...
Seat belt restraint system
To ensure maximum physical restraint and safety protection from the seat belts, every passenger in your Kia Sorento
must keep their belt fastened whenever the vehicle is in motion:
...