Kia Sorento: SRS Control Module (SRSCM) Description

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Description

The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.

The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.

The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry stabilize.

It is possible that the SRSCM could activate the safety restraint devices but is guaranteed to fully function after prove-out is completed.

The SRSCM must perform a diagnostic routine and light a system readiness indicator at key-on. The system must perform a continuous diagnostic routine and provide fault annunciation through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.

The yaw rate and G sensor which are used in ESC are inside the SRSCM. The sensor signal is sent by a separate CAN signal between the ESC control module and SRSCM.

Kia Sorento: SRS Control Module (SRSCM) Description

SRSCM

SRS Control Module (SRSCM) Components

See also:

Manuals list