Kia Sorento: Auto Defogging Actuator Replacement - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Auto Defogging Actuator Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Auto Defogging Actuator Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
3.
Using a screwdriver or remover, remove the crash pad side cover (A).

4.
Disconnect the stopper (B) from the glove box (A).

5.
Disconnect the air damper (A) from the glove box (B).

6.
Disconnect the pins (A) and then remove the glove box (B).

7.
After loosening the mounting screws, then remove the crash pad side garnish [RH] (A).

8.
After loosening the mounting screws, then remove the crash pad under cover (A).

9.
After loosening the mounting screws, then remove the glove box housing (A).

10.
Disconnect the glove box lamp connector (A).

11.
Disconnect the connector and then remove the auto defogging actuator (A) after loosening the mounting screws.

12.
Install in the reverse order of removal.
Auto Defogging Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator ...
Blower
...
See also:

Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Blower Resistor Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0318