Kia Sorento: Auto Defogging Actuator Inspection - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Auto Defogging Actuator Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Auto Defogging Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the auto defogging actuator operates to the close position when connected in reverse.

1. -
2. -
3. OPEN
4. CLOSE
5. Sensor (+ 5V)
6. Feedback signal
7. Sensor ground


4.
Connect the auto defogging actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminals 6 and 7.
Specification
Door position
Voltage (V)
Error detecting
Defog OFF (CLOSE)
0.45
    The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a ...
    1. Disconnect the negative (-) battery terminal. 2. Remove the cowl side trim. (Refer to Body - "Crash Pad") 3. ...
    See also:

    Diagnosis Of Immobilizer Faults
    - Communication between the ECM and the SMARTRA. - Function of the SMARTRA and the transponder. - Data (stored in the EC ...

    Wave Form
    ...

    Evasive Steering Assist function: (if equipped)
    The Evasive Steering Assist function integrated into the Forward Collision-Avoidance Assist architecture on your Kia Sorento is Emergency Steering. Emergency Steering (Driver steering assist) ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.054