Kia Sorento: Auto Light Sensor Inspection - Auto Lighting Control System - Body Electrical SystemKia Sorento: Auto Light Sensor Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Inspection

In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.
The auto light control doesn't work if the pin sunlight supply (5V regulated power from Ignition 1 power to sunlight sensor) is in short circuit with the ground.
If IGN1 ON, The IPM monitors the range of this supply and raises up a failure as soon as the supply
    Operate the auto light switch, then check for continuity between terminals of multi-function switch connector....
    1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor (A) from crash pad upper side by using screw (-) driver. ...
    See also:

    Components
    ...

    Removal
    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

    Knock Sensor (KS) On Vehicle Inspection
    On Vehicle Inspection 1. The engine control system can be more quickly diagnosed for problems with the KDS. (Refer to "DTC ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0476