Kia Sorento: Brake Line Removal - Brake System - Brake SystemKia Sorento: Brake Line Removal

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Brake System / Brake Line Removal

1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
  
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

5.
Remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~29.4 N.m (2.5 ~3.0 kgf.m, 18.1 ~21.7 lb-ft)

Front

Rear

Brake Line Components
...
Brake Line Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3. ...
See also:

Description and Operation
Description and Operation The component of the air conditioner is basically as shown in the figure below. As the refrigerant circulates between each part, it continuo ...

Luggage Side Trim Repair Procedures
Removal and Installation 1. Remove the 2nd and 3rd seat assembly. (Refer to Seat (Rear) - "Rear Seat Assembly") ...

Climate Control Air Filter Replacement
1. Disconnect the stopper (B) from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0468