Kia Sorento: Canister Removal - Evaporative Emission Control System - Emission Control SystemKia Sorento: Canister Removal

Kia Sorento (XM, 2011-2015) Service Manual / Emission Control System / Evaporative Emission Control System / Canister Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter and canister close valve.

5.
Disconnect the vapor tube quick-connector (A).
6.
Remove the canister assembly bracket (D) after removing the mounting bolts (B) and nut (C).

7.
Remove the canister braket (B) installation bolt (A).

8.
Remove the fuel tank air filter & canister close valve assembly (A) after rotating it in the direction of the arrow in the figure.

Inspection
[Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied. ...
Canister Inspection
1. Check for the following items visually. A. Cracks or leakage of the canister B. Loose connection, distorti...
See also:

Engine compartment
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake fluid reservoir 4. Air cleaner 5. Fuse box 6. Positive battery terminal 7. Negative battery terminal 8. Windshield washer fluid r ...

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0491