Kia Sorento: Child restraint system - Safety features of your vehicleKia Sorento: Child restraint system

Kia Sorento (XM, 2011-2015) Owner's Manual / Safety features of your vehicle / Child restraint system

Children riding in the vehicle should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver.

According to accident statistics, children are safer when properly restrained in the rear seats than in the front seat. Larger children not in a child restraint should use one of the seat belts provided.

You should be aware of the specific requirements in your country. Child and/or infant safety seats must be properly placed and installed in the rear seat. You must use a commercially available child restraint system that meets the requirements of the Federal Motor Vehicle Safety Standards (FMVSS).

Child restraint systems are designed to be secured in vehicle seats by seat belt, or by a tether anchor and/or LATCH anchors (if equipped).

Children could be injured or killed in a crash if their restraints are not properly secured. For small children and babies, a child seat or infant seat must be used. Before buying a particular child restraint system, make sure it fits your vehicle seat and seat belts, and fits your child.

Follow all the instructions provided by the manufacturer when installing the child restraint system.

WARNING

WARNING

To reduce the chance of serious or fatal injuries:

Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts may be activ...
For small children and babies, the use of a child seat or infant seat is required. The child seat or infant seat should be of appropriate size for the child and should be installed in accordance wit...
See also:

Climate Control Air Filter Replacement
1. Disconnect the stopper (B) from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). ...

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0389