Kia Sorento: Crankshaft Damper Pulley Removal and Installation - Timing System - Engine Mechanical SystemKia Sorento: Crankshaft Damper Pulley Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Removal and Installation

1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the passenger engine room side cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the passenger front tire.
4.
Remove the crankshaft damper pulley(A).

Tightening torque :
166.6 ~ 176.4 N.m (17.0 ~ 18.0 kgf.m, 122.9 ~ 130.1 lb-ft)

  
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.
    1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt auto tensioner(A). ...
    1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pullty") 2. Remove the front oil seal(A). ...
    See also:

    Battery Cleaning
    Cleaning 1. Make sure the ignition switch and all accessories are in the OFF position. 2. ...

    Panorama Sunroof Switch Inspection
    1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 screws holding ...

    General Service Information
    Protection Of The VehicleAlways be sure to cover fenders, seats, and floor areas before starting work.    The support rod must be ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0542