Kia Sorento: Drive Belt Tensioner Removal and Installation - Timing System - Engine Mechanical SystemKia Sorento: Drive Belt Tensioner Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Removal and Installation

1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt auto tensioner(A).

Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

  
Tensioner pulley bolt is left-hands screw.
3.
Remove the drive belt tensioner (A).

Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

4.
Install in the reverse order of removal.
Idler Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler(A). Tightening torque : ...
Crankshaft Damper Pulley Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the passenger engine room side cover. (Refer to Engin...
See also:

Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

Head Lamps Component (1)
1. Head lamp assembly 2. Head lamp high beam bulb 3. Head lamp low beam bulb 4. Dust cap 5. Turn signal lamp socket & bulb ...

Rear Driveshaft Inspection
1. Check the driveshaft boots for damage and deterioration. 2. Check the ball joint for wear and damage. 3. Che ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0484