Kia Sorento: Cylinder Head Cover Installation - Cylinder Head Assembly - Engine Mechanical SystemKia Sorento: Cylinder Head Cover Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Cover Installation

1.
Install cylinder head cover.
(1)
The hardened liquid gasket sealant located on the upper area between timing chain cover and cylinder head should be removed before assembling cylinder head cover.
(2)
After applying liquid gasket sealant to locations (A) and (B), it should be assembled within 5 minutes.

Bead width : 2.5 mm (0.10 in.)

(3)
Install the cylinder head cover (A) by tightening the bolts as following method.

Tightening torque :
1st step : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2nd step : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

  
    1. Disconnect the battery negative terminal. 2. Remove the engine cover. 3. Remove the air duct and air cleaner assembly. ...
    1. Camshaft bearing cap 2. Camshaft front bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust CVVT assembly 6. Intake CVVT assembly 7. Exhaust camshaft upper bearing ...
    See also:

    Component Location
    1. Auto light sensor 2. Head lamps 3. Lighting switch (Auto) 4. Tail lamps 5. IPM (Intelligent intergrated Platform Module) ...

    Specifications
    Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current value(mA) ...

    Intelligent Speed Limit Assist malfunction and limitations
    Intelligent Speed Limit Assist malfunction Check Driver Assistanc ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0619