Kia Sorento: Drive Belt Removal and Installation - Timing System - Engine Mechanical SystemKia Sorento: Drive Belt Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Timing System / Drive Belt Removal and Installation

1.
For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A).

2.
Install the drive belt (A).
Rotate the drive belt tensioner arm (A) counterclockwise moving the tensioner pulley bolt with wrench. After putting the belt on the tensioner pulley, release the tensioner pulley slowly.
Crankshaft pulley → A/C pulley → Alternator pulley → Idler #1 pulley → Idler #2 pulley → Water pump pulley → Tensioner pulley.

Components
1. Intake camshaft 2. Exhaust camshaft 3. Intake CVVT assembly 4. Exhaust CVVT assembly 5. Timing chain 6. Timing chain guide 7. Timing chain tensioner arm 8. Timing chain ten...
Drive Belt Inspection
1. Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt.    ...
See also:

Water pump Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the dr ...

Alternator Circuit Diagram
   ...

AC Inverter Oultet Installation
1. Install the power outlet switch. 2. Install the rear console cover. 3. Connect the negative (-) battery term ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0569