Kia Sorento: Emergency Fastening Device (EFD) Installation - Seat Belt Pretensioner - RestraintKia Sorento: Emergency Fastening Device (EFD) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least thirty seconds.
3.
Install the EFD with a bolt (B).

Tightening torque:
39.2~53.9 Nm(4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the EFD connector (A).
5.
Install the center pillar trim. (Refer to the Body group- Interior trim)
6.
Install the door scuff trim. (Refer to the Body group- Interior trim)
7.
Insert the seat belt to the anchor pretensioner.
  
Make sure the lock pin is connected in properly.
8.
Attaches EFD cover pad (A) on EFD.

  
Do not reuse the EFD cover pad (A).
9.
Reconnect the battery negative cable.
10.
After installing the EFD, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Emergency Fastening Device (EFD) Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the EFD cover pad (A). ...
Brake System
...
See also:

Door Locks and Security Systems in the Kia Sorento
Understanding how to properly operate the door locks on your Kia Sorento ensures total convenience, passenger safety, and complete vehicle security. Whether you are using advanced keyless entry f ...

Brake Line Repair procedures
Removal ...

Troubleshooting
Troubleshooting Symptom Suspected causes Repair Vehicle pulls to one side Front suspension fault or d ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0546