Kia Sorento: Exhaust Emission Control System
Kia Sorento (XM, 2011-2015) Service Manual / Emission Control System / Exhaust Emission Control System
- Description
- Catalytic Converter Description
- Catalytic Converter Removal
- Catalytic Converter Installation
- CVVT (Continuously Variable Valve Timing) System Description
- CVVT (Continuously Variable Valve Timing) System Operation Principle
- [CVVT System Mode]
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped.
In this case, use it a...
Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine
modifications and the addition of special control components.
Modifications to the combustion chamber, intake manifold,...
See also:
Replacement
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Description
BSD is a system that uses two magnetic wave radar sensors attached on
the rear bumper to measure the distance from the following vehicles and provides
the sensing and (visual and auditory) al ...
Seat Belt Buckle Switch (BS) Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The se ...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © xm.ksmanual.com 2014-2026