Kia Sorento: Filler-Neck Assembly Removal - Fuel Delivery System - Engine Control / Fuel SystemKia Sorento: Filler-Neck Assembly Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Removal

1.
Lift the vehicle.
2.
Disconnect the fuel filler hose (A).
3.
Disconnect the ventilation tube quick-connector ( B).

4.
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

5.
Remove the rear-LH wheel, tire and the inner wheel house.
6.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).

Fuel Line Installation
1. Install in the reverse order of removal....
Filler-Neck Assembly Installation
1. Install in the reverse order of removal. Filler-neck assembly bracket installation nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)...
See also:

Front Body C
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Input/Output Specification
Connector Pin Lay Out IMS input/output pin information No Signal Name I/O Contents Remark A1 - - - ...

Radiator Repair procedures
Removal and Installation 1. Disconnect the battery negative ( - ) terminal. 2. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0489