Kia Optima Manuals

Kia Sorento: Hazard Lamp Switch Removal - Lighting System - Body Electrical SystemKia Sorento: Hazard Lamp Switch Removal

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Removal

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).
3.
Remove the heater control unit connectors (A).
4.
Remove the heater control unit (A) with hazard switch.
(Refer to HA group - "Heater & A/C Control Unit")
Door Mood Lamp Installation
1. Install the door mood lamp and connector. 2. Install the front door trim. 3. Connect the negative battery terminal....
Hazard Lamp Switch Installation
1. Install the heater control unit to the center fascia panel. 2. Install the center fascia panel....
See also:

Rear Hub - Carrier Components
1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...

Troubleshooting
Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. ...

Oil Pressure Switch Inspection
1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026