Kia Optima Manuals

Kia Sorento: Head Lamps Replacement - Lighting System - Body Electrical SystemKia Sorento: Head Lamps Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Lighting System / Head Lamps Replacement

Bulb (HID)
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the lamp assembly.
4.
Remove the dust cover.
5.
Remove the ignitor clip (A) from the lamp assembly.
6.
Disconnect the ignitor connector.
7.
Remove the ignitor and bulb (A).
8.
Installation is the reverse of removal.
  
Turn the head lamp switch off to avoid high voltage
Be careful not to damage the bulb and use genuine bulbs only
•
Do not apply excessive force and fit it correctly.
•
Confirm the bulb locking
Bulb (high/low)
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the lamp assembly
4.
Remove the dust cover.
5.
Turn the bulb socket (A) counterclockwise and then remove it.
6.
Remove the bulb (A) from socket.
7.
Installation is the reverse of removal.
Turn signal lamp
1.
Turn the head lamp switch off.
2.
Remove the lamp assembly
3.
Turn the bulb socket (A) counterclockwise and then remove the turn signal lamp bulb (B).
Ballast
1.
Turn the head lamp switch off.
2.
Disconnect the power connector from the lamp.
3.
Remove the head lamp assembly.
4.
Remove the ballast (A) after loosening the screws (4EA).
5.
Installation is the reverse of removal.
  
•
Turn the head lamp switch off to avoid high voltage.
  
•
HID lamp shall not be used on other cars.(Fire may occur.)
•
Fire may occur when HID lamp initially lights due to the fact that arc-discharge generates high voltage (max. 20,000V) and high current (12-13A), and are different from the halogen lamp specification.
•
Install the dust cover after confirming the locking state between bulb and bulb holder.
•
When testing the HID head lamp, turn the power on or off with switch between power supply and lamp because of high voltage.
•
Do not operate the head lamp switch with the bulb not installed, because it generates spark momently.
Head Lamps Installation
1. Install the head lamp bulbs. 2. Reassemble the head lamp bulb covers. 3. Reassemble the head lamp assembly after connec...
Head Lamps Adjustment
Head Lamp Aiming Instructions The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions. ...
See also:

Hood Adjustment
Adjust Hood 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjust th ...

Removal
   In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be inju ...

Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026