Kia Optima Manuals

Kia Sorento: High Pressure Fuel Pump Removal - Fuel Delivery System - Engine Control / Fuel SystemKia Sorento: High Pressure Fuel Pump Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Fuel Delivery System / High Pressure Fuel Pump Removal

  
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
  
When removing the fuel pump fuse, a Diagnostic Trouble Code (DTC) may occur.
Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the air cleaner and the air intake hose
(Refer to Engine Mechanical System - “Intake And Exhaust System”)
4.
Disconnect the fuel pressure control valve connector (A).
5.
Remove the ignition coil (B).
6.
Disconnect the fuel feed tube quick-connector (A).
7.
Remove the high pressure fuel pipe.
(1)
Remove the installation nut (B) from the high pressure fuel pump with the special service tool [SST No.: 09314-3Q100]
(2)
Remove the installation nut (C) from the delivery pipe with the special service tool [SST No.: 09314-3Q100]
(3)
Remove the purge control solenoid valve.
(Refer to Engine Control Systme - “PCSV”)
(4)
Remove the function block (D), and then remove the high pressure fuel pipe.
8.
Remove the installation bolts (E), and then remove the high pressure fuel pump from the cylinder head assembly.
  
Unscrew in turn the two bolts in small step (0.5 turns). In case of fully unscrewing one of the two bolts with the other bolt installed, the housing surface of the cylinder head may be broken because of tension of the pump spring.

Delivery Pipe Installation
   • Install the component with the specified torques.    ...
High Pressure Fuel Pump Installation
   • Be sure to check the low pressure fuel hose quick-connector (A) is completely connected to the high pressure fue...
See also:

Head Lamps Component (2)
1. Head lamp assembly 2. Head lamp high beam bulb 3. Head lamp low beam bulb (HID & ignitor) 4. Dust cap 5. Turn signal lamp socket & bulb ...

Audio Remote Control Removal
1. Remove the driver airbag module. (Refer to Restraint - "Airbag module") 2. Remove the steering wheel front cover (A) after ...

Personalized profile and vehicle settings
When you pair a registered smartphone with a driver profile, your Kia Sorento automatically configures stored comfort settings (such as unlocking doors via Digital Key 2) to match that active use ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026