Kia Sorento: ICM Relay Box Inspection
| 1. |
There should be continuity between the No.1 and No.3 terminals
when power and ground are connected to the No.2 and No.10 in the ICM-A.
|
| 1. |
There should be continuity between the No.16 and No.15 terminals
when power and ground are connected to the No.13 and No.14 in the ICM-A.
|
| 1. |
There should be continuity between the No.8 and No.20 terminals
when power and ground are connected to the No.13 and No.12 in the ICM-A.
|
| 1. |
There should be continuity between the No.19 and No.7 terminals
when power and ground are connected to the No.13 and No.11 in the ICM-B.
|
| 1. |
There should be continuity between the No.12 and No.22 terminals
when power and ground are connected to the No.21 and No.22 in the ICM-B.
|
| 1. |
There should be continuity between the No.17 and No.4 terminals
int the ICM-A when power and ground are connected to the No.2 and No.1
in the ICM-B.
|
| 1. |
There should be continuity between the No.20 and No.16 terminals
when power and ground are connected to the No.17 and No.6 in the ICM-B.
|
| 1. |
There should be continuity between the No.15 and No.13 terminals
when power and ground are connected to the No.5 and No.9 in the ICM-B.
|
| 1. |
There should be continuity between the No.6 and No.18 terminals
in the ICM-A when power and ground are connected to the No.4 and No.3
in the ICM-B.
|
Heater & A/C Control Unit (DATC) Component
Connector Pin Function
Connector
Pin No
Function
Connector
Pin No
Function
A
1
Battery (+)
A
29
...
Front Seat Switch Repair Procedures
Inspection
[Front Seat]
1.
Remove the console upper cover.
(Refer to Body - "Console Upper Cover")
...
Propeller Shaft Removal and Installation
1.
After making a match mark on the flange yoke and transfer companion,
remove the propeller shaft mounting bolts (A).
Tightening torque:
...