Kia Optima Manuals

Kia Sorento: Propeller Shaft Removal and Installation - Propeller Shaft Assembly - Driveshaft and axleKia Sorento: Propeller Shaft Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Driveshaft and axle / Propeller Shaft Assembly / Propeller Shaft Removal and Installation

1.
After making a match mark on the flange yoke and transfer companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

3.
After making a match mark on the flange yoke and 4WD coupling companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
  
Do not reuse bolts.

4.
Install in the reverse order of removal.
  
•
When assembl ying propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.
Propeller Shaft Components
1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft...
Differential Carrier Assembly
...
See also:

Relay Box (Engine Compartment) Inspection
1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay box. Power Relay (Type A) ...

Power Mosfet (DATC) Inspection
1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be rep ...

Heated Steering wheel Inpection
1. Measure a resistance of NTC and Heated pad. A. NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10% (25°C) ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026