Kia Sorento: Inspection - Line Pressure Control Solenoid Valve - Automatic Transaxle Control System - Automatic Transaxle SystemKia Sorento: Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve / Inspection

1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Disconnect the solenoid valve connector (A).

4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the resistance is within the specification.
Circuit Diagram
...
Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will...
See also:

Front Seat Assembly Repair Procedures
Removal and Installation 1. Disconnect the battery negative ( - ) terminal. 2. ...

Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room U ...

Front Body B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0453