Kia Sorento: Measurement Method
| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
System operation. Using the infotainment/climate switchable controller
System operation
Ventilation
Set the air intake to to optimize cabin airflow
inside your
Kia Sorento.
Set the air intake control to ex ...
Auto Defogging Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging sensor cover (A).
3.
Disconnect t ...
Oil Pressure & Oil Temperature Sensor (OPTS) Removal and Installation
Removal
1.
Disconnect the battery negative ( - ) terminal.
2.
Remove the intak ...