Kia Sorento: Mode Control Actuator Inspection - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Mode Control Actuator Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Mode Control Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defog mode when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the mode control actuator operates to the vent mode when connected in reverse.

1. -
2. -
3. Defrost mode
4. Vent mode
5. Sensor ground
6. Feedback signal
7. Sensor (+ 5V)


4.
Connect the mode control actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 5 and 6.
Specification
Door position
Voltage (V)
Error detecting
Vent
0.45
    The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing th...
    1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side crash pad side cover. ...
    See also:

    Cylinder Block Repair procedures
    Disassembly ...

    Front Radar Installation
    Special Service Tool Tool Name / Number Illustration Description Digital Incli ...

    ATF Warmer Removal and Installation
    Removal 1. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under cove ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0661