Kia Sorento: Mode Control Actuator Replacement - Heater - Heating,Ventilation And Air ConditioningKia Sorento: Mode Control Actuator Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Heater / Mode Control Actuator Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's side crash pad side cover.

3.
After loosening the mounting screws, remove the crash pad lower panel (A).
4.
Push the lock pin (B), disconnect the diagnosis connector (C).

5.
After loosening the mounting bolts, then remove the reinforce panel (A).

6.
Remove the driver's side shower duct after loosening the screw.
7.
Disconnect the connector and then remove the mode control actuator (A) after loosening the mounting screws.

8.
Install in the reverse order of removal.
Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuat...
Auto Defogging Actuator Description
The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a ...
See also:

Power Window Switch Repair Procedures
Removal Power Window Main Switch 1. Remove the driver side front door trim. (Refer to Body - "Front Door Trim") ...

Shift Lever Installation
1. Install in the reverse order of removal.    Set shift lever and inhibitor ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0498