Kia Sorento: Occupant Detection system (ODS) Installation - SRSCM - RestraintKia Sorento: Occupant Detection system (ODS) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / SRSCM / Occupant Detection system (ODS) Installation

1.
Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat)
2.
Install the front passenger seat assembly.
(Refer to the Body group - seat)
3.
Reconnect the battery negative cable.
4.
After installing the ODS, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require suppression and the passenger airbag is enabled.
Occupant Detection system (ODS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat assembly. (Ref...
Circuit Diagram
Circuit Diagram (2) Circuit Diagram (3)...
See also:

Center Side Airbag (CSAB) Removal and Installation
Removal 1. Disconnect the battery negative ( - ) terminal. ...

Panorama Sunroof Guide Repair Procedures
Removal 1. Remove the mechanism assembly. (Refer to Panorama Sunroof - "Mechanism Assembly") ...

Power Window Motor Repair Procedures
Removal Front Power Window Motor 1. Remove the front door trim. (Refer to Body - "Front Door Trim") ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0458