Kia Sorento: Parking Brake Cable Removal
| Parking brake pedal Type |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
|
| 3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
| 4. |
Remove the parking brake cable adjusting nut (A) and the fixing
clip (B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 7. |
Raise the vehicle, and make sure it is securely supported.
|
| 8. |
Remove the rear wheel & tire.
|
| 9. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 10. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 11. |
Installation is reverse of removal.
|
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 4. |
Raise the vehicle, and make sure it is securely supported.
|
| 5. |
Remove the rear wheel & tire.
|
| 6. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
| 7. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
| 8. |
Installation is reverse of removal.
|
Parking Brake Pedal Assembly Adjustment
Specification
Item
Specification
Coil Resistance (Ω)
0.5 [20°C(68°F)
...
Component Location
[Engine Room]
1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
Direct Electro Hydraulic Actuator Coupling Installation
1.
Install in the reverse order of removal.
•
...