Kia Sorento: Parking Brake Pedal Assembly Adjustment - Parking Brake System - Brake SystemKia Sorento: Parking Brake Pedal Assembly Adjustment

Kia Sorento (XM, 2011-2015) Service Manual / Brake System / Parking Brake System / Parking Brake Pedal Assembly Adjustment

Parking Brake Pedal Stroke Adjustment
1.
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables.
2.
Adjust the adjusting nut(A) for parking barke pedal stoke 8 ~ 9 notches when operating effort is 294N(30kgf, 66lbf)

  
1.
The parking brake adjustment must be carried out after adjusting the rear shoe.
2.
After adjusting parking brake, notice following matter.
1)
Must be free from clearance between adjusting nut and pin.
2)
Check securely that the brake is not dragging.
Parking Brake Pedal Assembly Installation
1. Install the holding clip (A, B) after fixing the parking brake cable. 2. Install the parking brake pedal, and then install the parking ...
Parking Brake Cable Removal
Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower pan...
See also:

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts may be act ...

Description
An inverter is a device that transforms the DC voltage from the battery into an AC voltage (115 V). The inverter can power various electrical devices that consume 150 W or less, including mob ...

Room Lamp Removal
[General] 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver t ...

Copyright © xm.ksmanual.com 2014-2026