Kia Sorento: Piston and Connecting Rod Inspection - Cylinder Block - Engine Mechanical SystemKia Sorento: Piston and Connecting Rod Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cylinder Block / Piston and Connecting Rod Inspection

Connecting Rod

1.
Check the connecting rod end play.
Using a feeler gauge, measure the end play while moving the connecting rod back and forth.

End play :
Standard : 0.10~ 0.25 mm (0.0039 ~ 0.0098 in.)
Limit : 0.35 mm (0.0138 in.)

A.
If out-of-tolerance, install a new connecting rod.
B.
If still out-of-tolerance, replace the crankshaft.
2.
Check the connecting road bearing oil clearance.
(1)
Check the matchmarks on the connecting rod and cap are aligned to ensure correct reassembly.
(2)
Remove 2 connecting rod cap bolts.
(3)
Remove the connecting rod cap and bearing half.
(4)
Clean the crank pin and bearing.
(5)
Place plastigage across the crank pin.
(6)
Reinstall the bearing half and cap, and torque the bolts.

Tightening torque
17.7~21.6 N.m (1.8 ~ 2.2 kgf.m, 13.0 ~ 15.9 lb-ft) + 78 ~ 82
    See also:

    Basic Service Symbols
    There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning Do ...

    Inside rearview mirror
    Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. WARNING - Rear visibility Do not place objects in the rear seat or ...

    Component Location (1)
    1. Smart key unit 2. Interior antenna 3 3. Interior antenna 2 4. Interior antenna 1 5. Buzzer ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0656