Kia Sorento: Power Door Lock Actuators Inspection - Power Door Locks - Body Electrical SystemKia Sorento: Power Door Lock Actuators Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators Inspection

Front Door Lock Actuator
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front door module.
(Refer to Body - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Rear Door Lock Actuator
1.
Remove the rear door trim.
(Refer to Body - "Rear door")
2.
Remove the rear door module.
(Refer to Body - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Lock Actuator Inspection
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Front Door Lock Switch
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front door module.
(Refer to Body - "Front door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Rear Door Lock Switch
1.
Remove the rear door trim.
(Refer to Body - "Rear door")
2.
Remove the rear door module.
(Refer to Body - "Rear door")
3.
Disconnect the connectors from the actuator.

4.
Check for continuity between the terminals in each switch position according to the table.

Tailgate Switch
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate")
2.
Disconnect the 4P connector from the actuator.

3.
Check for continuity between the terminals in each switch position according to the table.

Component Location
1. Driver power window main switch 2. Passenger window switch 3. IPM (Intalligent intergrated Platform Module) 4. Door lock switch 5. Tailgate lock actuator & switch 6. Front do...
Power Door Lock Switch Removal
Driver Power Window Main Switch 1. Disconnect the negative battery terminal. 2. Remove the front door trim. (Refer to Body - "Fron...
See also:

Circuit Diagram
...

Clean air: (if equipped)
The clean air function turns ON automatically when the ENGINE START/STOP button is ON. The clean air function turns OFF automatically when the ENGINE START/STOP button is OFF. ...

Special Service Tools
Tool (Number and name) Illustration Use Alternator pulley remover wrench (09373-27000) Removal and installation of alternator pulley ...

Copyright © xm.ksmanual.com 2014-2026