Kia Sorento: Power Mosfet (DATC) Replacement - Blower - Heating,Ventilation And Air ConditioningKia Sorento: Power Mosfet (DATC) Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the passenger side crash pad under cover (A).

3.
Disconnect the connector and then remove the power mosfet (A) after loosening the mounting screws.

4.
Install in the reverse order of removal.
Power Mosfet (DATC) Inspection
1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be replaced. (Aft...
Climate Control Air Filter Description
The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventional dust filte...
See also:

Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. ...

Telemetics Unit (TMU) Inspection
1. After replacing the TMU unit, access Dealer Engineering Mode in head unit. (Refer to MTS system - "TMU Dealer Engineering Mode") 2 ...

Dimensions. Engine
Dimensions Item 6, 7 Seats in (mm) Base X Line (1) ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0392