Kia Sorento: Power Mosfet (DATC) Inspection - Blower - Heating,Ventilation And Air ConditioningKia Sorento: Power Mosfet (DATC) Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Power Mosfet (DATC) Inspection

1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Blower Resistor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. D...
Power Mosfet (DATC) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. D...
See also:

Engine Oil Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

Rear combination lamp Installation
1. Install the tailgate combination lamp assembly after replacing the bulb. 2. Install the lamp cover to the tailgate after connecting the ...

Button Engine Start System Repair Procedures
Removal 1. Remove the crash pad center panel. (Refer to Body - "Crash Pad Center Panel") ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0628