Kia Sorento: Rear combination lamp Installation - Lighting System - Body Electrical SystemKia Sorento: Rear combination lamp Installation

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Lighting System / Rear combination lamp Installation

1.
Install the tailgate combination lamp assembly after replacing the bulb.
2.
Install the lamp cover to the tailgate after connecting the lamp connector.
3.
Install the rear combination lamp assembly after replacing the bulbs and connecting the lamp connector.
Rear combination lamp Removal
1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the con...
Troubleshooting
Symptom Possible cause Remedy One lamp does not light (all exterior) Bulb burned out Replace bulb Socket, wiring or ground faulty Repair...
See also:

Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof trim") 2. Disconnect the power cable (A). 3. ...

Digital Key 2 maintenance for a pre-owned vehicle. Limitations of the system
Digital Key 2 maintenance for a pre-owned vehicle Purchasing a pre-owned vehicle When taking ownership of a pre-owned Kia Sorento, verify whether any previous access credentials remain active in t ...

Front Hub / Knuckle / Tone Wheel Removal and Installation
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0383