Kia Sorento: Removal - Multifunction switch - Body Electrical SystemKia Sorento: Removal

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Multifunction switch / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing 3 screws.

3.
Disconnect the light switch connector (A) and the wiper switch connector (B).

4.
Remove the wiper switch (A) by pushing the lock pin (B).
  
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

5.
Remove the steering wheel.
(Refer to Steering System - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to Restraint - "Airbag module")
7.
Loosen the screws from the multifunction switch assembly (A).

Component
...
Installation
1. Install the multifunction switch. 2. Install the clock spring and steering wheel. 3. Install the steering column upper ...
See also:

Automatic climate control system (If equipped)
1. A/C display 2. Driver's temperature control knob 3. AUTO (automatic control) button 4. Front blower OFF button 5. Front fan speed control switch 6. Mode selection button 7. Dual tempera ...

Specification
Ignition System Ignition Coil Item Specification Primary Coil Resistance (Ω) 0.62 ...

Limp Home Function
1. Limp Home By Tester If the PCM(ECM) detects the fault of the SMARTRA or transponder, the PCM(ECM) will allow limp home function of the immobilizer. Limp hom ...

Copyright © xm.ksmanual.com 2014-2026 - 0.088