Kia Sorento: Installation - Multifunction switch - Body Electrical SystemKia Sorento: Installation

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Multifunction switch / Installation

1.
Install the multifunction switch.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after removing 3 screws. ...
Inspection
Lighting Switch Inspection 1. With the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not a...
See also:

USB Charger Circuit Diagram
Circuit Diagram [Floor Console Tray / Rear Console Cover] [Front Seat Back Board] [Lu ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") ...

Front Stabilizer Bar Repair procedures
Removal 1. Disconnect the (-) battery terminal. 2. Remove the front wheel and ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0721