Kia Sorento: Seat Belt Buckle Switch (BS) Installation - SRSCM - RestraintKia Sorento: Seat Belt Buckle Switch (BS) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Installation

  
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seatbelt buckle & buckle switch.

Tightening torque
Bolt B:
39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)

4.
Install the front seat assembly. . (Refer to the Body group- Front seat)
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to the ...
Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostatic c...
See also:

Kia Sorento Seats and Cabin Configuration
The Kia Sorento interior combines versatile seating configurations with intuitive ergonomic design to ensure optimal comfort and utility for all occupants. Understanding the controls, proper seat ...

Vacuum Pump Repair procedures. Brake Line Components and Components Location
Vacuum Pump Repair procedures Removal [THETA lll 2.5 T-GDI] 1. Disconnect the battery negative ( - ) ca ...

General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0567