Kia Sorento: Seat Belt Pretensioner (BPT) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

3.	Connect the seat belt pretensioner connector.

Install the seat belt pretensioner with bolts (A, B).

Tightening torque

Bolt A : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

Install the seat belt upper mounting bolt.

Tightening torque :

39.2~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb.ft)

6.	Install the center pillar trim. (Refer to the Body group- Interior trim)

7.	Install the door scuff trim. (Refer to the Body group- Interior trim)

Insert the seat belt to the emergency fastening device.

Make sure the lock pin is connected in properly.

Attaches emergency fastening device cover pad (A) on emergency fastening device.

Do not reuse the emergency fastening device cover pad (A).

10.	Reconnect the battery negative cable.

11.

After installing the seat belt pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Seat Belt Pretensioner (BPT) Removal

1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the emergency fastening device cover ...

Emergency Fastening Device (EFD) Description

Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver and passeng...

Kia Sorento: Seat Belt Pretensioner (BPT) Installation

See also:

Manuals list