Kia Sorento: SRS Control Module (SRSCM) Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 4. |
Loosen the bolts and then remove the rear air vent duct (A).
|
| 5. |
Pull up the lock of the SRSCM connector, the disconnect the connector
(A).
|
| 6. |
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove
the SRSCM.
|
SRS Control Module (SRSCM) Components
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
...
See also:
Line Pressure Control Solenoid Valve
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fr ...
Oil Cooler Installation
1.
Apply a light coat of engine oil to the oil cooler packing surface (A),
and then install the oil cooler with fix bolt (B).
Tightening torque:
...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © xm.ksmanual.com 2014-2026