Kia Sorento: SRS Control Module (SRSCM) Installation - SRSCM - RestraintKia Sorento: SRS Control Module (SRSCM) Installation

Kia Sorento (XM, 2011-2015) Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Install the SRSCM with the SRSCM mounting bolts.

Tightening torque :
8.0 ~ 12.0 N.m (0.8 ~ 1.2 kgf.m, 5.9 ~ 8.9 lb-ft)

  
Use new mounting bolts when replacing the SRSCMafter a collision.
4.
Connect the SRSCM harness connector.
5.
Install the rear air vent duct and floor console.
(Refer to Body - "Floor console")
6.
Reconnect the battery negative cable.
7.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
  
    1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. ...
    After replacing the SRSCM with a new one, MUST perform the...
    See also:

    Circuit Diagram
    ...

    AWD ECU Components and Components Location. AWD ECU Description and Operation
    AWD ECU Components and Components Location Component Location 1. AWD ECU AWD ECU Description and Operation De ...

    4WD ECU Input&Output Diagram
    ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0573