Kia Sorento: Steering Column and Shaft Disassembly - Electric Power Steering - Steering SystemKia Sorento: Steering Column and Shaft Disassembly

Kia Sorento (XM, 2011-2015) Service Manual / Steering System / Electric Power Steering / Steering Column and Shaft Disassembly

Universal joint assembly
1.
Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly.

Tightening torque :
49.0 ~ 58.8 N.m(5.0 ~ 6.0 kgf.m, 36.2 ~ 43.4 lb-ft)

2.
Reassembly is the reverse of the disassembly.
Key lock assembly
1.
Make a groove on the head of special bolts (A) by a punch.

2.
Loosen the special bolt using a screw driver and then remove the key lock assembly from the steering column assembly.
3.
Reassembly is the reverse of the disassembly.
Steering Column and Shaft Removal
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels c...
Steering Column and Shaft Inspection
1. Check the steering column for damage and deformation. 2. Check the joint bearing for damage and wear. 3. Check the tilt...
See also:

Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Fuel Pump Installation
1. Install in the reverse order of removal.    Be careful of fuel pump direc ...

Antenna Coil Removal and Installation
Removal 1. Remove the steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel") ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0589