Kia Sorento: Steering Column and Shaft Removal - Electric Power Steering - Steering SystemKia Sorento: Steering Column and Shaft Removal

Kia Sorento (XM, 2011-2015) Service Manual / Steering System / Electric Power Steering / Steering Column and Shaft Removal

1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
4.
Disconnect the connector & lock nut (A) and then remove the steering wheel by using special service tools (09561-11001).

Tightening torque :
39.2 ~ 49.0 N.m (4.0 ~ 4.5 kgf.m, 28.9 ~ 36.2 lb-ft)

  
    After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom...
    Universal joint assembly 1. Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly. Tightening t...
    See also:

    Removal
    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor connecto ...

    Special Service Tools
    Special Service Tools Tool Name / Number Illustration Description Piston expan ...

    Pressure Sensor Description and Operation
    Description The AWD ECU makes a Motor Pump (Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generate ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0552