Kia Sorento: TJ Joint Installation - Driveshaft Assembly - Driveshaft and axleKia Sorento: TJ Joint Installation

Kia Sorento (XM, 2011-2015) Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Installation

1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot.
2.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and retainer ring (B) on the driveshaft splines (C).

3.
Add specified grease to the joint boot as much as it was wiped away at inspection.
4.
Install the both boot band.
5.
Using the SST(09495-3K000), secure the TJ boot bands.

Clearance (A): 2.0 mm (0.0787 in.) or less

6.
Install the front driveshaft.
(Refer to Driveshaft Assembly -
    TJ Joint Inspection
    1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...
    Dynamic Damper Components
    1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retai...
    See also:

    Troubleshooting
    Troubleshooting Symptom Cause of the symptom Remedy Excessive play in steering ...

    Instrument cluster
    Figure 1. Type A Figure 2. Type B The actual instrument cluster layout and graphic appearance in your specific Kia Sorento trim level may vary slightly from these re ...

    Compressor Inspection
    Inspection Visual inspection 1. Check for damage to the disc portion of the disc and hub assembly. If t ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0563