Kia Sorento: TPMS Sensor Removal - Tire Pressure Monitoring System - Suspension SystemKia Sorento: TPMS Sensor Removal

Kia Sorento (XM, 2011-2015) Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Removal

Tire Removal
1.
Deflate tire & remove balance weights.
  
The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.
Avoid tire/tool contact with the valve on dismount.
Dismount should end near the valve.

Sensor Removal
  
Handle the sensor with care.
1.
Remove the valve nut.

  
The valve nut should not be re-used.
2.
Discard the valve assembly.
TPMS Sensor Description
1. Mode (1) Configuration State A. All sensors should be in the Low Line state. ...
TPMS Sensor Installation
Sensor Fit    • Handle the sensor with care. • ...
See also:

Front seat adjustment for manual seat systems (if equipped)
To manually adjust the front seat position, locate and activate the ergonomic control levers mounted on the outer side and front lower base of the seat cushion assembly. Moving forward and backwa ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear ...

Circuit Diagram
...

Copyright © xm.ksmanual.com 2014-2026